Back where I started...almost.

The bead roller frame is now strengthened together with some other smaller modifications. The motorization is not ready yet but the roller can be used again with hand crank.

Before:


:

After:



 Before:


After:


Other modifications:

Grease fittings added.




Lift mechanism for the upper shaft. The black knob on the tightening screw is from the winch that was bought for this project. I accidentally broke the shaft when dismantling winch, came in handy here when it has a M6 thread. No need for tools when spring load is to be adjusted. Plan to make similar arrangement for the tightening bolt for the upper roll (the long bolt).


Painting.









Miscellaneous pictures.





 




Comments

Post a Comment

Popular posts from this blog

Ready! At least for now!

Image
The end product! Footswitch and battery setup. Other details: Electrical work ongoing. Wiring diagram: "Original plan" ended up using a bigger junction box with mounting plate witch made the installation easier. Future plans Mainly use it! Getting rid of the battery by adding an AC/DC converter is on the agenda.    
Read more

How to fasten the electrical motor to the bead roller.

Image
What is it I want to build?  I need to figure out how to fix the motor to the bead roller. I'm thinking I want to be able to convert the roller back to hand crank use if needed, for example the motor breaks or the construction I'm making does not work, so I will try to make a bolted bracket for the motor. I need to be able to adjust the motor position to get the shaft aligned as good as possible. As I will have to dismantle the bead roller and probably need to do some welding to the frame, it would make sense to stiffen up the construction while I'm at it. I think the easiest way to stiffen the bead roller would be to weld square tubing or a thick plate to the back side of the bead roller frame. As I need a way to get the motor more towards the back of the roller a suitable tick plate might solve two problems at once. The plan is now to strengthen the body of the bead roller at the same time as preparing fastening point for the motor assembly. Purchasing material. With some...
Read more

Speed and direction control

Image
 I purchased a PWM (pulse width modulation) speed controller from an online shop. There was very little information on the sight about the controller it only said max current 60A, so I thought that should be sufficient. When I got it it is clear by looking at it that it is not intended for use anywhere near nominal currents of 60A but maybe for really short periods it can withstand it.   Terminal marking on casing is in Chinese I think, but on the circuit board it is indicated in English. Hooking up the controller. I used the cables from the remote controller from the winch they had end terminals on with correct markings so it was straight forward. I did some tests with the controller. One was to remove the display unit and did not make any difference, works fine without it so that one I will leave out. I see no use for it. I tried to measure the amps when bead rolling also but my multimeter freaked out so I did not get any result. Need to try that again at some other time. Th...
Read more